-
-
-
Depending on the year of release of the attachment can vary.
Front bumper
-open the hood.
-under the hood take out the caps and Unscrew the screws (inserted and twisted from top to bottom) that secure the upper part.
-perimeter of the lower part and pull out the caps and Unscrew the screws (twisted and inserted from the bottom up).
-depending on which side we will disassemble, wrenched the wheel.
-in the wheel wells, Unscrew the screws, remove the caps and removed the wheel arch liners (you can not fully remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-remove the license plate.
-Unscrew the three screws in the grille.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (don't want to break the wires and hoses).
-remove the connectors from the fog lights (if any).
-switched the hoses to the washer (can leak fluid).
Rear bumper
-open the trunk lid and the tailgate.
- Unscrew the screws on each side and pull themselves rear lights.
the rear lights take out the caps.
in the corners of the opening and pull out the pistons and remove the pads.
under pads take out the rivets that attach the Central part.
-take out the caps on the perimeter of the lower part (inserted from the bottom up).
-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner and mud flaps.
for wheel arch liners Unscrew one screw (can be caps) on each side (spun upwards) holding the corners of the bumper to the wings.
-with the assistant release the latch in the wings (pull the corners apart).
-carefully (don't want to break the wires) pulls the bumper back.
-remove connectors from electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español