-
-
-
Peugeot 5008 II (2017-2023)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood, unscrew the two screws (spun down) that secure the top of the front bumper.
-from the bottom, unscrew the screws (spun up) that secure the bottom.
-turn the wheels to the side.
-we release the lining of the arches from the bumper (hold on the latches, take the bottom and pull towards you).
-in the wheel wells, unscrew the screws and release the fender liner (front).
-take the fender liner to the side and unscrew two screws on each side (spun down) that secure the sides of the bumper to the wings.
-at the junction of the bumper and the wing, we release the clamps (you need to pull it towards you).
-we release the latches that secure the upper part of the bumper (you need to press through the holes with a flat screwdriver).
-with an assistant, gently pull the bumper forward (look behind the wires).
-disconnect electrical connectors.
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew the two screws.
-we release the lining of the arches from the bumper (hold on the latches, take the bottom and ourselves).
-in the wheel wells, unscrew the screws that secure the fender liner (rear).
-for the fender liner, unscrew one screw on each side (spun down) that secures the sides of the rear bumper to the wings.
-at the bottom, unscrew the seven screws (spun up).
-we release the latch in the wings (pull the corners of the bumper towards you).
-we release the latches under the rear lights.
-we release the latches in the opening of the trunk (indicated by blue arrows, you need to press with a screwdriver).
-with an assistant, pull the rear bumper back (be careful not to break the wires).
-on the left side, disconnect the electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español