-
-
-
Peugeot 3008 II (2016-2023)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood, unscrew the two screws (spun down).
-on the perimeter of the lower part, unscrew the screws (spun up).
-turn the wheels to the side.
-we release the lining of the arches from the bumper (hold on the latches, pull the bottom towards you).
-unscrew the screws and release the fender liner (front).
-for the fender liner, unscrew two screws on each side (spun down) that secure the corners of the bumper to the wings.
-we release the sides from the clips in the wings (you need to pull the clip and pull the corners of the bumper down).
-we release the latches that secure the upper part of the front bumper (you need to press with a flat screwdriver).
-with an assistant, gently pull the bumper forward (look behind the wires).
-disconnect electrical connectors (if any).
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew the two screws.
-we release the lining of the arches from the bumper (hold on the latches, pull the bottom towards you).
-unscrew the screws that secure the fender liner (rear).
-for the fender liner, unscrew one screw on each side (spun down) that attach the corners of the bumper to the wings.
-from the bottom, unscrew the six screws (spun up).
-we release the latch in the wings (pull the corners of the rear bumper towards you).
-we release the latches under the rear lights.
-with an assistant, pull the rear bumper back (be careful not to break the wires).
-disconnect electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español