How to remove front and rear bumper Peugeot 607

Depending on the year of the attachment points are slightly different.

Front bumper

-(if equipped) pull up the headlight washers and release the latches from the top.

-open the hood.

-under the hood take out the rivets and remove the lining on the grille.

-Unscrew the screw and release the clips (need rotate 90 degree) that secure the top.

-Unscrew the screws that attach the lower part.

-depending on which side we will disassemble, wrenched the wheel.

-wheel arches, peel the fender liner.

-for wheel arch liners Unscrew two screws on each side that attach the angles to the wings.

-through the wheel arches in the wings, you have to turn 90 degree clamps.

-pulls the bumper forward (don't want to break the wires).

-remove the connectors from the equipment (if any).

Rear bumper

-take out the caps and Unscrew the screws that attach the lower part.

-wheel arches, peel the fender liner.

-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings.

-open the trunk lid.

-in the trunk take out the caps and remove the rear side trim panel (need to access the inner part of the wings and rear panel).

-from the trunk in the wings Unscrew four screws on each side (twisted upside down).

-through the holes Unscrew the two nuts in the rear.

-we release the latch in the wings (pull the corners down).

-with the assistant gently pulls the bumper back, see not to break the wires.

-snap together the connectors of the equipment (if any).

How to remove front and rear bumper Peugeot 605