-
-
-
Peugeot 5008 I (2009-2016)
Front bumper
-open the hood.
-under the hood, unscrew the two screws and take out the two clips that secure the upper part.
-around the bottom part unscrew the eight screws that secure the lower part.
-depending on which side we will disassemble, wrenched the wheel.
-in the wheel wells, unscrew the screws and peel the fender liner (you can not fully remove).
-for wheel arch liners unscrew one screw on each side that attach the angles to the wings.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (don't want to break the wires and hoses).
-remove the connectors from the fog lights.
-(if any) disconnected hoses to the washer (can leak fluid).
Rear bumper
-wheel arches free lockers (you can not fully remove).
-for wheel arch liners unscrew one screw on each side (twisted upside down) holding the corners of the bumper to the wings.
-unscrew the screws that attach the lower part (spun up).
-we release the latch in the wings (pull the corners themselves).
-with an assistant, carefully (don't want to break the wires) pulls the bumper back.
-remove connectors from electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español