-
-
-
Despite the appearance of differing before and after restyling, bumper mounted almost the same.
Front bumper
-open the hood.
-under the hood take out the caps (inserted from top to bottom) that secure the upper part.
-around the bottom part Unscrew the screws (spun up).
-depending on which side we will disassemble, wrenched the wheel.
-wheel arches take out the rivets and removed the lockers (lockers can not fully remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (don't want to break the wires).
-remove the connectors from the fog lights (if any).
Rear bumper
-open the trunk lid.
-remove tail lights (one plastic nut on the outside and one from the trunk).
-Unscrew the rear lights one screw on each side.
-Unscrew the screws that attach the lower part (spun up).
-wheel arches take out the caps and removed the wheel arches (you can not fully remove).
-Unscrew one screw on each side that attach the angles to the wings.
-we release the latch in the wings (pull the corners themselves).
-remove the back bumper (don't want to break the wires).
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español