Depending on the year and model of attachment can vary.
-open the hood.
-under the hood, take out the four clips and remove upward the radiator grille.
-take out the clips under the grille that secure the upper part.
-around the bottom part Unscrew the screws and release the clips.
-depending on what direction we will analyze wrenched the wheel.
-in the wheel wells, Unscrew the screws, remove the caps and release the fender liner.
-Unscrew one screw on each side that attach the angles to the wings.
-(most difficult) through the wheel arches have turned to the wings 90 degrees to the two clamps on each side (need to make a hook from steel wire).
-pulls the bumper forward from the guides (don't want to break the wires).
-remove the connectors from the equipment (if any).
-open the lid (door) of the trunk.
-in the opening of the trunk, Unscrew the six screws.
-wheel arches Unscrew the screws that attach the angles to the wings.
-Unscrew the screws (nuts) that attach the lower part.
-gently pulls back bumper (don't want to break the wires).
-remove the connectors from the sensors (if any).