Depending on the model year and body type of attachment are different.
Front bumper
-open the hood.
-under the hood, Unscrew the two screws (spun down) that secure the top.
-from the bottom Unscrew the seven screws (spun up).
-wrenched the wheel to the side.
-in the wheel wells, Unscrew the screws and take out the clips holding the wheel arch liners (no need to remove).
-move the wing flaps to the side (need to access the inside of the wing).
-for wheel arch liners Unscrew two screws on each side holding the bumper corners to the wings.
-release the latch under the hood that hold the upper part (grille).
-with the assistant pulls the bumper forward (don't want to break the wires).
-remove the connectors from the fog lights.


Rear bumper
-open the trunk lid.
-remove tail lights.
-Unscrew the two screws (if present) that secure the upper part.
-Unscrew the screws and take out the rivets that attach the lower part.
-wheel arches take out the caps (Unscrew the screws) and free lockers (no need to remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings and locking strap.
-now you need to pull the strap on itself, this will exempt the latches in the wings (two on each side).
-remove the license plate together with the frame and Unscrew the nut under it.
-with the assistant pulls back (don't want to break the wires).
-snap together the connectors of the equipment (if any).



