-
-
-
Depending on the year of release of attachment is different.
Front bumper
-open the hood.
-under the hood, pull four clips.
-from the bottom Unscrew the screws (spun upwards) holding the bottom of the bumper.
-depending on which side we will disassemble, wrenched the wheel.
-wheel arches take out the caps and removed the wheel arches (the front part).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-we release the latch in the wings (ha pull the corners themselves).
-pulls the bumper forward (don't want to break the wires).
-left side remove the fog lamp connectors (if any).
Rear bumper
-open the trunk lid.
-(depending on year) Unscrew the screws and remove lining.
-in the opening of the trunk, Unscrew the screws.
-in the upper part and pull out two plugs and Unscrew the screws under them.
-take out the caps (inserted from the bottom up) that secure the lower part.
-wheel arches take out the rivets and removed the arch liners (no need to remove).
-attach the fender liner to the side and pulled them caps holding the corners of the bumper.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper backwards (look for wires).
-snap together the connectors of the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español