Front bumper
-Unscrew the wheel left or right depending on which side of the bumper will loosen first.
-Unscrew the screws that attach the fender liner to the bumper.
-near the fog lights, remove the grille. To do this, get two pistons on each side.
-under the bars Unscrew one bolt on each side (under the inner sprocket, twist upward).
-pulls the bumper itself.
-remove the connectors from the fog lights (if any).
-if you have headlight washers, passenger side disconnected hoses (if the tank is liquid, it will flow).
-the bumper is cleared.
Rear bumper
-wheel arches take out the rivets that attach the fender liner to the bumper.
-remove the rear trim panel in the trunk.
-for paneling Unscrew three nuts 13 on each side.
-pulls the bumper itself (not to scratch the paint on the wings, better to do it with a helper).
-if there are sensors, releasable connector.
-the bumper is cleared.