-
-
-
Fiat Panda III (2011-2023)
Depending on the year the site of attachment may vary slightly.
Front bumper
-open the hood.
-under the hood, Unscrew the four screws.
-unscrew the screws (rivets) around the perimeter of the bottom (spun up).
-wrenched the wheel to the side.
-wheel arches unscrew three screws on each side, release the fender liner (front part).
-attach the fender liner to the side and unscrew one screw on each side holding the bumper corners to the wings.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (look for wires).
-snap together the connectors with electrical equipment (if any).
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew the two screws.
-from the bottom unscrew the screws (rivets) that attach the lower part.
-wheel arches unscrew two screws on each side and removed the wheel arches (rear).
-unscrew one screw on each side holding the bumper corners to the wings.
-we release the latch in the wings (pull the corners themselves).
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors of the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español