Front bumper

-open the hood.

-under the hood, Unscrew the screws that secure the top.

-Unscrew the four screws (spun up) that secure the lower part.

-wrenched the wheel to the side.

-in the wheel wells, Unscrew the screws and peel the fender liner (front part).

-move the wing flaps to the side and Unscrew two screws on each side holding the bumper corners to the wings.

-pulls the bumper forward (look for wires).

-snap together the connectors of electrical equipment.

The attachment of the front bumper of the Fiat Albea

The attachment of the front bumper of the Fiat Albea

Rear bumper

-open the trunk lid.

in the boot remove the side trim.

for skins, wings, Unscrew two screws on each side.

-from the bottom Unscrew the screws (spun up).

-Unscrew the screws in the opening of the trunk.

-in the wheel wells, Unscrew the screws and peel the fender liner (rear part).

-move the wing flaps to the side and Unscrew one screw on each side holding the bumper corners to the wings.

-with the assistant pulls the bumper back.

The attachment of the rear bumper Fiat Albea