How to remove front and rear bumper Fiat Fiorino / Qubo

Fiat Fiorino (Qubo) III (2007-2022)

Depending on the year of manufacture, the attachment points may vary slightly.

Front bumper

-open the hood.

-under the hood, unscrew the four screws (spun down).

-unscrew the ten screws (spun down) that secure the lower part of the bumper (spun up).

-unscrew the screws in the wheel arches that secure the fender liner (front).

-remove the fender liner to the side and unscrew four screws on each side (the screws are hard to reach) that attach the sides of the bumper to the wings.

-we release the latch in the wings (pull the corners of the bumper towards you).

-with an assistant, pull the bumper forward (look for the wires).

-remove connectors from electrical equipment (if any).

Rear bumper

-open the tailgate.

-in the opening of the trunk, Unscrew the four screws

-remove the rear lights.

-under the rear lights, unscrew two screws on each side (spun down).

-unscrew the screws around the perimeter of the lower part of the bumper (spun up).

-in the wheel wells, unscrew the screws that secure the fender liner (rear).

-move the fender liner to the side and Unscrew one screw on each side that attach the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners towards you).

-with an assistant, pull the bumper back (look for the wires).

-disconnect electrical connectors (if any).