How to remove front and rear bumper Fiat Scudo (2007-2016)

Fiat Scudo II (2007-2016)

Depending on the year of manufacture, the attachment points may differ.

Front bumper

-open the hood.

-under the hood take out four pistons and remove the grille (holds on latches, pull up).

-under the grille take out six caps.

-turn the wheels to the side.

-in the wheel wells, unscrew the screws that secure the fender liner (front).

-for the fender liner, unscrew one screw on each side that attach the corners of the bumper to the wings.

-behind the fender liner, approximately at the level of the headlights, we release two plastic clips each (you need to make a hook from steel wire and turn it ninety degrees).

-unscrew the screws and release the clips from the bottom (spun up).

-with an assistant, pull the bumper forward from the guides in the wings (look for the wires).

-remove connectors from electrical equipment (if any).

Rear bumper

-open the trunk lid.

-in the opening of the trunk, unscrew the six screws.

-in the wheel arches, we release the fender liner (rear).

-unscrew one screw on each side that secures the sides of the bumper to the wings.

-from the bottom, unscrew the two nuts and two screws.

-we release the latch in the wings (pull the corners of the bumper).

-with an assistant, pull the bumper back (look for the wires).

-disconnect electrical connectors (if any).

How to remove front and rear bumper Fiat Scudo (1995-2007)