Front bumper
-open the hood.
-under the hood, Unscrew the four screws that secure the top (spun down).
-Unscrew the six screws around the perimeter of the bottom (spun up).
-wrenched the wheel to the side.
-wheel arches Unscrew two screws and one plastic nut on each side, peel the fender liner (front part).
-attach the fender liner to the side and Unscrew two screws on each side holding the bumper corners to the wings.
-pulls the bumper forward (look for wires).
-snap together the connectors of the fog lights (if any).
Rear bumper
-open the trunk lid.
-in the opening of the trunk, Unscrew the three screws.
-exempt in the trunk side trim.
-for casings, the internal part of the wing, Unscrew one screw on each side.
-from the trunk, Unscrew the nuts and remove the tail lights.
-under the rear lights Unscrew two screws on each side.
-Unscrew the screws (spun up) that secure the lower part.
-wheel arches Unscrew two screws on each side and removed the wheel arches (rear).
-for wheel arch liners Unscrew two screws on each side (spun upwards) holding the corners of the bumper to the wings.
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors for the license plate lighting and Parking assist.