Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood, Unscrew the two screws.

-Unscrew the four screws around the perimeter of the bottom (spun up).

-wrenched the wheel to the side.

-wheel arches free lockers (front part).

-attach the fender liner to the side and Unscrew two screws on each side holding the bumper corners to the wings.

-pulls the bumper forward (look for wires).

-snap together the connectors with electrical equipment (if any).

The attachment of the front bumper Fiat Seicento

The scheme of fastening of the front bumper Fiat Seicento

Rear bumper

-open the trunk lid.

-remove tail lights.

-Unscrew the four screws (spun down) that secure the upper part.

-from the bottom Unscrew the two screws that secure the lower part.

-wheel arches free the wheel arches (rear).

-Unscrew one screw on each side holding the bumper corners to the wings.

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of electrical equipment.

The attachment of the rear bumper Fiat Seicento

Diagram of rear bumper Fiat Seicento