Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-under the hood we take out fourteen pistons and remove three plastic trims.
-under the trims we take out three pistons and two hood stops (inserted from top to bottom), which secure the radiator grille and the upper part of the front bumper.
-turn the wheels depending on which side you will disassemble.
-in the wheel arches we take out two pistons on each side (need to be rotated 90°), which secure the fender liners (front part).
-move the fender liners to the side and unscrew one screw on each side that secures the corners to the wings. We take out the two plastic clips into which these screws are screwed.
-unscrew the screws and pull out the caps around the perimeter at the bottom of the bumper (twisted and inserted from bottom to top).
-with an assistant, we release the bumper from the latches in the wings and under the headlights, and carefully pull it onto ourselves.
-remove the connectors from the fog lights (if any).
-remove the connector from the parking sensors (if equipped).
-if there are headlight washers, disconnect the hoses.
How to remove the rear bumper
-open the trunk lid.
-in the trunk opening, unscrew the two screws that secure the upper part of the rear bumper.
-from the bottom, unscrew the screws and take out the pistons that secure the lower part.
-in the wheel ones, we take out the caps that secure the fender liners (rear part) and unscrew the screws that secure the mudguards and the corners of the bumper to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches in the trunk opening.
-with an assistant, carefully pull the bumper back.
-disconnect the connectors for parking sensors and lighting devices.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
