Lexus LC500 (2018-2024) how to remove bumpers.

Depending on the year of manufacture, the mounting locations may vary slightly.

How to remove the front bumper

-open the hood.

-under the hood, take out fifteen pistons (inserted from top to bottom) and remove the plastic trim (consists of three parts).

-we release the rubber seals (held by clips).

-under the trim, take out the four pistons and unscrew the four screws (twisted and inserted from top to bottom) that secure the upper part of the front bumper and the radiator grille.

-(if any) behind the radiator grille emblem, disconnect the electrical connector.

-from the bottom, unscrew the eight screws (twisted from bottom to top) that secure the lower part.

-turn the wheels depending on which side we will disassemble.

-in the wheel arches, pull out three pistons on each side and release the clips that secure the fender liners (front part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the headlights.

-with an assistant, carefully pull the bumper forward (watch the wires and hoses).

-disconnect the connectors of the electrical equipment.

-if there are headlight washers, disconnect the hoses.

How to remove the rear bumper

-open the trunk lid.

-take out the pistons and release the plastic linings.

-under the trims, Unscrew the two screws that secure the upper part of the rear bumper.

-from the bottom we take out the pistons that secure the lower part.

-in the wheel arches we release the fender liners (rear part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the rear lights.

-with an assistant, pull the bumper back (watch the wires).

-disconnect the connectors of the electrical equipment.

-now you can remove the side parts of the bumper, they are held on by three screws, two clamps and latches each.