-
-
-
Lexus RX II XU30 (2004-2009), RX 330 , RX 350, RX 400h, Toyota Harrier.
Depending on the year of manufacture, the mounting locations may vary slightly.
Front bumper
-open the hood.
-take out three (five) pistons between the headlights (inserted from top to bottom).
-wrenched the wheel depending on which side of the bed will disassemble.
-wheel arches unscrew the screws that attach the fender liner.
-remove the fender liner to the side and Unscrew one screw on each side that attach the angles to the wings.
-unscrew the screws and take out the caps on the perimeter in the lower part of the bumper.
-with the assistant release the bumper clips and gently pulls on itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses.
Rear bumper
-open the trunk lid.
-unscrew at the corners of the opening one screw on each side.
-in the trunk take out the rivets that secure the rear trim panel.
-is released from the latch (pull up) and remove the rear trim panel.
-the plating through the holes, unscrew the four head nuts.
-in the wheel wells, unscrew the screws holding the wheel arch liners and mud flaps (not to remove the wheels easier to turn a ratchet with a nozzle).
-remove the fender liner to the side and unscrew one screw on each side (spun upwards) holding the corners to the wings.
-on the perimeter in the bottom part unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-assistant free the bumper from the clips in the wings and gently pulls on itself.
-remove the electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español