Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-under the hood, take out the eleven pistons and remove the plastic trim (radiator protection).
-under the trim we take out the five pistons (inserted from top to bottom) that secure the upper part of the front bumper (radiator grille).
-from the bottom, unscrew the eight screws (twisted from bottom to top) that secure the lower part.
-turn the wheels depending on which side we will disassemble.
-in the wheel arches, release two latches on each side (need to be rotated 90 degrees), which secure the fender liners (front part).
-behind the fender liners, unscrew one screw on each side that secures the corners to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches under the headlights.
-with an assistant, carefully pull the bumper forward (watch the wires and hoses).
-disconnect the connectors of the electrical equipment.
-if there are headlight washers, disconnect the hoses.
How to remove the rear bumper
-open the trunk lid.
-in the trunk opening, use a flat screwdriver to remove two plugs.
-under the plugs, unscrew the two bolts that secure the upper part of the rear bumper.
-from the bottom we take out the six pistons and unscrew the eight screws (twisted and inserted from the bottom up) that secure the lower part.
-in the wheel arches we release the fender liners (rear part).
-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings (you will need a 10mm socket, extension and ratchet).
-release the latches in the wings (pull the corners toward you).
-release the latches under the rear lights.
-release the latches in the trunk opening.
-with an assistant, pull the bumper back (watch the wires).
-disconnect the parking sensor connectors (if equipped).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
