Lexus NX 200 (2015-2021) how to remove bumpers

Lexus NX I AZ10 (2015-2021) NX 200t/300, NX 300h, NX 200.

Depending on the year of manufacture, the mounting locations may vary slightly.

How to remove the front bumper

-open the hood.

-under the hood, take out ten pistons and remove the plastic trim (protection of the engine compartment).

-under the trim, take out the four pistons and unscrew the four screws that secure the upper part of the front bumper and the radiator grille.

-from the bottom, unscrew ten screws (twisted from bottom to top) that secure the lower part.

-turn the wheels to the side.

-in the wheel arches, unscrew one screw, take out four pythons on each side that secure the wheel arch linings (front part).

-we release the wheel arch linings from the bumper (they are held on by latches, we pull them towards us from the bottom up).

-under the wheel arch trims, take out one piston on each side that secures the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-with an assistant, carefully pull the bumper forward (make sure not to break the wires).

-disconnect the connectors of the electrical equipment.

How to remove the rear bumper

-open the trunk lid.

-in the trunk opening we take out four plugs.

-under the plugs, unscrew the four screws that secure the upper part of the rear bumper.

-from the bottom side, unscrew the two screws and take out the eight pistons that secure the lower part (lining).

-in the wheel arches, pull out three pistons on each side, release them from the latches (pull them towards you) and remove the wheel arch linings.

-under the trims we take out one piston on each side that secures the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the rear lights.

-release the latches in the trunk opening.

-with an assistant, carefully pull the bumper back.

-disconnect the connectors of the electrical equipment (if any).