-
-
-
Front bumper
-under the hood take out the caps (inserted upside down) and remove the grille.
-under the grille, Unscrew the two screws that secure the upper part of the bumper.
-on the perimeter in the bottom part Unscrew the seven screws (spun up).
-wrenched the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches take out the rivets and removed the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the wings (pull over), bumper pulls gently on yourself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnect the hose (should prepare a container, which will merge a liquid).
Rear bumper
-in the trunk, Unscrew the screws and take out the caps, remove the rear trunk lining (rests on the latch).
-under the casing Unscrew the four nuts that secure the bumper to the rear.
-we release the side trim (you need to access the inner part of the wings).
-For butovymi casings Unscrew two nuts (below rear lights) and two screws (in the wings, twist upward) on each side.
-on the perimeter in the lower part and pull out the caps that secure the lower part of the bumper.
-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant gently pulls the bumper itself.
-remove the electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español