Lexus LS III XF30 (2001-2006) LS 430, Toyota Celsior.
Depending on the year of manufacture, the mounting locations may vary.
Front bumper
-turn the wheels to the left or right, depending on which side you will disassemble.
-in the wheel arches on each side we take out two pistons and unscrew two screws in the lower part (twisted from bottom to top) that secure the fender liners.
-move the fender liners to the side and unscrew one screw and two nuts on each side that secure the bumper to the wings.
-unscrew five screws along the perimeter at the bottom (twisted from bottom to top).
-with an assistant, release the latches under the headlights.
-carefully pull the bumper towards you.
-remove the connectors from the fog lights (if any).
-remove the connector from the parking sensors (if equipped).
-if there are headlight washers, disconnect the hose (you should prepare a container into which the liquid will be drained).
Rear bumper
-open the trunk lid.
-in the trunk, take out the pistons and remove the rear panel trim.
-remove the plugs in the side trims (they are held on by latches).
-from the trunk, unscrew eight nuts and two screws.
-around the perimeter in the lower part we take out the caps that secure the lower part.
-in the wheel arches, unscrew one screw on each side that secures the corners of the bumper to the wings.
-with an assistant, carefully pull the bumper towards you.
-remove the connectors from the electrical equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
