Dodge Intrepid II (1997-2004)
Front bumper
-open the hood.
-under the hood, unscrew the screws that secure the upper part of the bumper.
-depending on which side we will disassemble, turn the wheels.
-wheel arches take out two pistons on each side, which are the fender liner (front).
-for the fender liner, unscrew the screws that attach the sides of the bumper to the wings.
-unscrew the screws that secure the bottom of the bumper.
-we release the latch in the wings (pull the corners).
-with an assistant, pull the bumper forward (look for the wires).
-disconnect electrical connectors (if any).
Rear bumper
-open the trunk lid.
-in the opening of the trunk take out the caps.
-from the bottom, unscrew the screws (spun up).
-wheel arches take out the caps that secure the fender liner (rear).
-unscrew one screw on each side that attach the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors.