How to remove front and rear bumper Dodge Caliber

Dodge Caliber (2006-2012)

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-under the hood, Unscrew the two screws and take out the three clips (twisted and inserted top to bottom) that secure the upper part.

-depending on which side we will disassemble, wrenched the wheel.

-wheel arches and floor and pull out the caps, Unscrew the screws and release the wheel arches (completely remove is not necessary).

-the fender liner, Unscrew the screws that attach the angles to the wings.

-perimeter of the lower part and pull out the caps that attach the bottom of the bumper.

-with the assistant pulls  the bumper with the rails in the wings (however, not to cut wires).

-remove the connectors from the fog lights.

Rear bumper

-open the trunk lid.

-in the opening of the trunk pulls out the five rivets that attach the upper part.

-Unscrew the screws from the bottom (if any).

-in the wheel wells, Unscrew the screws holding the fender liner (full wing flaps should not be removed).

-the fender liner, Unscrew the screws holding the corners of the bumper to the wings.

-with the assistant pulls the bumper back, freeing of locks in the wings.

-(if you have one) remove the connectors of electrical equipment.