Front bumper
Depending on the model year and version of the attachment may vary.
-under the hood, Unscrew the five screws (spun down).
-depending on the model: a breakaway side moldings (need to pry with a screwdriver to remove the latches) or take out the plugs and Unscrew one screw on each side (some models these screws may not be).
-remove the grille (closed fog lamps) and Unscrew one screw on each side.
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches Unscrew the screws that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side in the corners.
-Unscrew the screws around the perimeter at the bottom of the bumper (spun up).
-with the aide of tear corners with latches and pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
-remove the connector from the fog lamp.
-if you have headlight washers, disconnected the hoses. The liquid leaking on the ground, you need to prepare a suitable container.
Rear bumper
Depending on the model year and version of the attachment may vary.
-Unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).
-move the wing flaps to the side and Unscrew one screw on each side (spun up).
-in the trunk Unscrew two screws and remove rear trim and side shifts.
under the panels Unscrew the four screws.
-Unscrew the screws around the perimeter in the bottom (spun up).
-with the aide of tear corners with latches and pulls the bumper from the guides themselves.
-remove the electrical connector license plate light.
-remove connector from the PDC (if any).
How to remove front and rear bumper SEAT Leon II (2005-2012)
How to remove front and rear bumper SEAT Leon III (2012-2020)