How to remove the front and rear bumper SEAT Tarraco

SEAT Tarraco I (2018-2023)

Depending on the year of manufacture, the attachment points may vary slightly.

Front bumper

-open the hood.

-under the hood, unscrew the screws (spun down) that secure the upper part of the bumper (pad).

-from the bottom, take out eight caps and Unscrew the four screws (inserted and screwed up).

-unscrew the two screws in the lower bumper grille.

-turn the wheels, depending on which side we will disassemble.

-in the wheel arches, unscrew the screws that secure the fender liner and lining arches (front).

-we release the lining of the arches from the bumper (pull the bottom of the lining towards you).

-for the fender liner, unscrew one screw on each side (spun up) that attach the corners to the wings.

-we release the clips in the wings (pull the corners of the bumper towards you).

-we release the clips behind the grille.

-with an assistant, gently pull the bumper forward (look behind the wires).

-disconnect electrical connectors.

Rear bumper

-open the trunk lid.

-(if any) in the opening of the trunk, unscrew the two screws.

-at the bottom, take out two pythons and unscrew the four screws.

-in the wheel wells, unscrew the screws that secure the fender liner and lining arches (rear).

-we release the lining of the arches from the latches in the bumper (pull the bottom towards you).

-for the overlays, unscrew one screw on each side that secures the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners of the bumper towards you).

-we release the latches under the rear lights.

-with an assistant, pull the rear bumper back (look for the wires).

-disconnect electrical connectors.