Front bumper

Depending on the model year and version of the attachment may vary slightly.

The bumper is removed along with the grille.

-under the hood, Unscrew the two screws (spun down) that secure the grille.

-Unscrew the screws and take out the caps on the perimeter in the lower part (inserted and spun up).

-Unscrew the wheel to the left or right side, depending on which side will parse the first.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side (twisted from top to bottom) that attach the angles to the wings.

-with the assistant pulling the edges to the sides and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp.

-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.

mounting locations for front bumper SEAT Alhambra (after 2011)

the scheme of fastening of the front bumper SEAT Alhambra (after 2011)

Rear bumper

Depending on the model year and version of the attachment may vary slightly.

-open the trunk lid and side panels removable access doors (need to access the rear part of the rear lights).

-under the hatches and pull out the cap, Unscrew the screws and remove the taillights by pulling

under the rear lights Unscrew two screws on each side (twisted upside down).

-Unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and Unscrew one screw on each side (spun up).

-Unscrew the screws around the perimeter in the bottom (spun up).

-with the aide of tear corners with latches and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

the attachment of the rear bumper SEAT Alhambra (after 2011)

diagram of rear bumper SEAT Alhambra (after 2011)