How to remove front and rear bumper SEAT Toledo (1998-2004)
SEAT Toledo II (1998-2004)
Front bumper
Depending on the version of the attachment may vary.
-under the hood, Unscrew the four screws (might be clips) (spun up).
-remove the top side covers (may not be) and bottom plug (you need to gently pry the edge with a screwdriver and rip the snaps).
-Unscrew under the pads and plugs screws.
-Unscrew the three screws in the bottom of the bumper (spun up).
-wrenched the wheel to the left or right side depending on which side
-we will analyze first.
-wheel arches Unscrew the screws that attach the fender liner.
-with the assistant pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
-remove the connector from the fog lamp.
-if you have headlight washers, disconnected the hoses. The liquid leaking on the ground, you need to prepare a suitable container.
Rear bumper
Depending on the version of the attachment may vary.
-Unscrew one bolt each side in the doorway of the trunk.
-Unscrew the screws in the wheel arches that secure the fender liner and the screws that attach the angles to the guide (to remove the wheels, loosen the ratchet with a nozzle).
-move the wing flaps to the side and Unscrew one screw on each side (spun up).
-Unscrew the screws around the perimeter in the bottom (spun up).
-with the assistant pulls the bumper from the guides on myself.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
