How to remove front and rear bumper SEAT Toledo (2004-2009)

SEAT Toledo III (2004-2009)

Front bumper

Depending on the version of the model the attachment is different.

-under the hood, Unscrew the four screws (spun down).

-in the Central decorative lattice Unscrew one screw on each side (in the models since the end of 2006, these screws are not).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side in the corners.

-Unscrew the eight screws at the bottom (spun up).

-with the aide of tear corners with latches and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp.

-if you have headlight washers, disconnected the hoses. The liquid leaking on the ground, you need to prepare a suitable container.

Rear bumper

Depending on the version of the attachment may vary.

-in the side panels remove the cap.

-under plugs Unscrew the retaining knobs and remove the tail lights.

-under the rear lights Unscrew two screws on each side.

-Unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and Unscrew one screw on each side (spun up).

-Unscrew the screws around the perimeter in the bottom (spun up).

-with the aide of tear corners with latches and pulls the bumper from the guides themselves.

-remove the electrical connector license plate light.

-remove connector from the PDC (if any).

How to remove front and rear bumper SEAT Toledo II (1998-2005)

How to remove front and rear bumper SEAT Toledo IV (2012-2019)