Front bumper

The bumper is removed along with the grille.

-under the hood take out the caps and remove the bar over the grille.

-under the strap, Unscrew the screws (spun down) and detach the clips that secure the grille and bumper to the body.

-Unscrew the screws at the bottom (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew two screws on each side that attach the bumper to the wings.

-with the aide of tear corners with latches and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp.

-if you have headlight washers, disconnect the hose from the pump. The liquid leaking on the ground, you need to prepare a suitable container.

mounting locations for front bumper SEAT Toledo IV (2011)

the scheme of fastening of the front bumper SEAT Toledo IV (2011)

Rear bumper

Depending on the version of the attachment may vary.

-in the opening of the trunk Unscrew two screws on each side that secure the tail lights.

-remove rear light clusters (mounted on the latches).

-Unscrew the screws in the wheel arches that secure the fender liner to the bumper (so as not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and Unscrew one screw on each side (may not be).

-Unscrew the screws around the perimeter in the bottom (spun up).

-assistant free the bumper from the clips in the wings and under the tail lights and pulled off of the guide itself.

-remove the electrical connector license plate light.

-remove connectors from Parking assist sensors (if any).

the attachment of the rear bumper SEAT Toledo IV (2011)

diagram of rear bumper SEAT Toledo IV (2011)

 

How to remove front and rear bumper SEAT Toledo II (1998-2005)

How to remove front and rear bumper SEAT Toledo III (2004-2009)