How to remove front and rear bumper Chrysler 300 M (Concorde)

Chrysler 300M (Concorde II) (1998-2004)

Depending on the year of manufacture and body type, the attachment points differ.

Front bumper

-open the hood.

-under the hood take out the caps (inserted from top to bottom) that secure the top.

-take out the caps around the perimeter at the bottom (inserted from the bottom up).

-turn the wheels left or right, depending on which side you will disassemble.

-in the wheel wells take out the caps and release the fender liner.

-for the fender liner, unscrew one screw on each side (spun up) that secure the corners.

-there are holes in the fender liner through which, according to the instructions (using a long wrench), you need to unscrew the nuts under the headlights, in practice it is more convenient to move the fender liner to the side

-with an assistant, we pull the bumper from the guides towards ourselves (we look for wires and hoses).

-remove connectors from electrical equipment (if any).

-disconnect the headlight washer hoses (if any).

Rear bumper

-open the trunk lid.

-in the opening of the trunk take out the caps.

-remove the lining of the trunk (you need to gain access to the inside of the wings).

-for the skins, unscrew the two nuts.

-from the trunk, unscrew the nuts and remove the rear lights.

-under the rear lights take out the caps.

-wheel arches take out three pistons on each side that secure the fender liner (rear).

-move the fender liner to the side and unscrew one screw on each side (spun up) that attach the corners of the bumper to the wings.

-unscrew the screws from the bottom (spun up).

-with an assistant, pull the bumper back from the guides in the wings (look for the wires).

-disconnect electrical connectors.