The attachment of bumpers ChryslerTown & Country , Voyager, GrandVoyager third (1996-2000) and fourth (2001-2007) generation is practically identical.

Front bumper

-open the hood.

-Unscrew three screws on each side and remove the headlights.

-in the opening of the headlight Unscrew the screws that attach the bumper to the wings (can be nuts).

-Unscrew the screws (spun down) that secure the top (the screws which attach the grille to the bumper remove unnecessary).

-Unscrew the screws (spun up) on the perimeter at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings.

-s the assistant pulls gently on the bumper itself.

-remove the connectors from the fog lights (if any).

-if you have headlight washers, the right side switched the hoses.

the attachment of the front bumper Chrysler Town & Country (Voyager) (1996-2007)

diagram of the headlamp Assembly Chrysler Town & Country (Voyager) (1996-2007)

the scheme of fastening of the front bumper Chrysler Town & Country (Voyager) (1996-2007)

Rear bumper

The bumper is very easy.

-in the wheel wells, Unscrew the screws holding the wheel arch liners (to remove the wheels, loosen the ratchet with a nozzle).

-at the corners of the opening of the trunk, Unscrew the two screws.

-at the bottom, take out the caps (inserted from the bottom up).

-with the assistant gently pulls the bumper itself from the guides.

-remove the connectors from the equipment (if any).

the attachment of the rear bumper Chrysler Town & Country (Voyager) (1996-2007)

the scheme of fastening the rear bumper of the Chrysler Town & Country (Voyager) (1996-2007)