Chrysler Pacifica CS I (2003-2008)
Front bumper
-open the hood.
-under the hood, unscrew the eight screws (spun down) that secure the upper part of the bumper and the grille (it is not necessary to remove the trim over the grille).
-at the bottom of the bumper take out five caps (inserted from the bottom up).
-turn the wheels to the side.
-in the wheel wells, Unscrew three screws on each side that secure the fender liner (front).
-unscrew two screws on each side and remove the headlights forward (the lower part of the headlights rests on the latches).
-through the openings of the headlights, unscrew two screws on each side (spun down) that secure the sides of the bumper to the wings.
-with an assistant, pull forward (look for the wires).
-disconnect connectors from electrical equipment.
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew two screws on each side and remove the rear lights (hold on the latches).
-under the rear lights, Unscrew one screw on each side.
-take out two pistons on each side in the trunk opening that secure the upper part of the bumper.
-in the wheel arches, unscrew two screws on each side, which are the fender liner (rear) and the side of the bumper.
-take out the four pistons from the bottom (inserted from the bottom up).
-with an assistant, we release the corners and pull the bumper back (look for the wires).
-disconnect electrical connectors.