How to remove front and rear bumper Chrysler 300 C (after 2011)
Depending on the model year and body type of attachment may vary.
Front bumper
-under the hood take out the eight clips (inserted from top to bottom) that secure the upper part.
-Unscrew the screws around the perimeter at the bottom.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches pulled three pistons on each side and removed the fender liner.
for wheel arch liners Unscrew one screw on each side holding the corners.
-we release the latch in the wings (pull the corners themselves) and between the upper part and wings above the headlights (need to pry with a flat head screwdriver).
-with the assistant pulls the bumper itself.
-remove the connectors from the equipment (if any).
-switched the hoses to the headlight washers.
Rear bumper
-wheel arches pulled three pistons on each side that attach the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side holding the corners of the bumper to the wings (spun up).
-on the perimeter in the bottom part pulls out four piston and Unscrew the six screws (twisted and inserted from the bottom up).
-we release the latch in the wings (pull the corners themselves) and the opening of the trunk.
-with the assistant pulls the bumper from the guides on myself.
-remove the connectors from the equipment (if any).