How to remove front and rear bumper Chrysler Sebring (1994-2000)

Chrysler Sebring I FJ/JX (1994-2000)

Depending on the year of manufacture and body type, the attachment points may vary slightly.

Front bumper

-open the hood.

-under the hood, unscrew the six screws that secure the grille and the upper part of the bumper.

-at the bottom of the bumper, unscrew the screws.

-turn the wheels to the side.

-in the wheel wells, unscrew three screws on each side that secure the fender liner (front).

-for the fender liner, unscrew two nuts on each side that secure the sides of the bumper to the wings.

-unscrew the two screws in the lower grille (if any).

-with an assistant, pull forward (look for the wires).

-disconnect connectors from electrical equipment.

Rear bumper

-open the trunk lid.

-in the trunk, remove the trim.

-for the skins, unscrew the nuts that secure the sides of the bumper.

-in the wheel wells, unscrew the screws holding the fender liner (rear).

-for the fender liner, unscrew one screw on each side that attach the corners to the wings.

-unscrew the two screws from the bottom (spun up).

-with an assistant, we release the corners and pull the bumper back (look for the wires).

-disconnect electrical connectors.

How to remove front and rear bumper Chrysler Sebring (2000-2006)

How to remove front and rear bumper Chrysler Sebring (2006-2010)