How to remove front and rear bumper Chrysler Town & Country (Voyager) (2008-2016)

The attachment of bumpers Chrysler Town & Country , Voyager, Grand Voyager (2008-2016) the same.

Front bumper

The bumper is removed along with the grille.

-under the hood, Unscrew the screws and take out the caps (twisted and inserted top to bottom) that secure the top part of the bumper and the grille .

-take out the caps (inserted from the bottom up) around the perimeter at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings.

-with the assistant release the latch and gently pulls the bumper itself.

-remove the connectors from the fog lights (if any).

-if you have headlight washers, disconnected the hoses.

-releasable connector Parking assist (if any).

Rear bumper

-wheel arches Unscrew three screws on each side holding the wheel arch liners (to remove the wheels, loosen the ratchet with a nozzle).

-open the boot lid and twisted in the opening two screws on each side.

-at the bottom, take out the caps (inserted from the bottom up) that secure the lower part.

-with the assistant gently pulls the bumper itself from the guides.

on the right side of releasable connector Parking assist (if any).

How to remove front and rear bumper Chrysler Town & Country (Voyager) (1996-2007)