How to remove front and rear bumper Chrysler 300C (2004-2010)

Chrysler 300C I (2004-2010)

Front bumper

-open the hood.

-under the hood take out four pistons (inserted from top to bottom).

-on the perimeter of the lower part, unscrew the nine screws (spun up) that secure the protection to the bumper.

-turn the wheels to the side.

-in the wheel wells, unscrew three screws on each side that secure the fender liner (front).

-for the fender liner, unscrew one screw on each side (spun up) that attach the corners of the bumper to the wings.

-with an assistant, pull the bumper forward from the guides in the wings (look for the wires and hoses).

-disconnect electrical connectors.

-disconnect the headlight washer hoses.

Rear bumper

-open the trunk lid and pulls out three pistons and two stops that secure the upper part.

-wheel arches pulled three pistons on each side that attach the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side holding the corners of the bumper to the wings (spun up).

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-with the assistant pulls the bumper from the guides themselves.

-remove the connectors from the equipment (if any).

How to remove front and rear bumper Chrysler 300C (2011+)