-
-
-
Chrysler Sebring III JS (2006-2010)
Depending on the year of manufacture and body type, the attachment points may vary slightly.
Front bumper
-open the hood.
-take out the caps and remove the air intake.
-under the hood take out the six caps that secure the upper part of the bumper.
-around the bottom of the bumper take out the caps (inserted from the bottom up).
-turn the wheels to the side.
-in the wheel wells, unscrew two screws on each side that secure the fender liner (front).
-behind the fender liner, one screw on each side that secures the corners of the bumper to the fenders.
-with an assistant, release the sides from the latches in the wings and pull them forward (look behind the wires and hoses).
-disconnect connectors from electrical equipment.
-disconnect the headlight washer hoses.
Rear bumper
-open the trunk lid.
-in the opening of the trunk take out four pistons (inserted from top to bottom).
-wheel arches take out the caps, which are fender liner (rear).
-for the fender liner, unscrew one screw on each side (spun up) that attach the corners to the wings.
-take out the two pistons from the bottom.
-with an assistant, release the sides from the latches in the wings and pull the bumper back (look for the wires).
-disconnect electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español