How to remove front and rear bumper SKODA RAPID

Front bumper

Depending on the model year and version of the attachment may vary slightly.

-open the hood, Unscrew two screws and remove two pistons (spun down).

-near the fog lights, remove the grille (mounted on the latches).

-under the bars Unscrew one screw on each side.

-Unscrew the screws around the perimeter at the bottom of the bumper (spun up).

-Unscrew the wheel to the left or right side, in depending on which side will dismantle.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew three screws on each side (spun upwards) holding the corners to the wings.

-with the aide of tear clips in the wings and under the headlights and pulls the bumper itself.

-remove connector from the PDC (if any).

-if you have fog lights, remove the connector.

-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.

Rear bumper

Depending on the model year and version of the attachment may vary slightly.

-in the trunk, side panels, openable lid.

-under the covers, Unscrew the screws, switched the connectors and remove the tail lights.

-Unscrew the screws around the perimeter in the bottom (spun up).

-Unscrew the screws in the wheel arches (not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and Unscrew one screw on each side in the corners (spun up).

-we release the latch in the wings and under the tail lamps.

-with the assistant pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).