-
-
-
Front bumper
Depending on the model year and version of the attachment may vary slightly.
-open the hood and Unscrew two screws and take out the two clips that secure the grille (spun down).
-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches Unscrew the screws that attach the fender liner to the bumper.
-move the wing flaps to the side and Unscrew two screws on each side that attach the bumper to the wings.
-remove side garnish grille (mounted on the latches).
-under grilles Unscrew one screw on each side.
-at the bottom, take out the caps and Unscrew the screws (inserted and spun up).
-pulls the bumper forward from the rails.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.
Rear bumper
-in the boot remove the side trim (you need to access the rear part of the rear lights).
-under coverings Unscrew the nuts and remove the tail lights.
-Unscrew the screws under the rear lights.
-in the wheel wells, Unscrew the screws holding the wheel arch liners (to remove the wheels, remove the ratchet with a nozzle).
-for wheel arch liners Unscrew one screw each side that attach the angles to the wings.
-at the bottom, take out the caps (inserted from the bottom up).
-with the assistant pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español