Front bumper

Depending on the model year and version of the attachment may vary slightly.

-open the hood and Unscrew the three screws in the opening between the headlights.

-Unscrew the screws and remove the headlamp.

-Unscrew the screws under the headlights.

-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.

-wheel arches Unscrew the screws that attach the fender liner.

-remove the pad (attached with snaps) and Unscrew two screws on each side.

-remove the side grille and Unscrew the screws under them.

-remove bumper traffic in front.

-remove the connector from the temperature sensor (if any).

-if you have fog lights, remove the connector.

-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.

the attachment of the front bumper SKODA OCTAVIA 1

scheme of fastening of front bumper SKODA OCTAVIA 1

Rear bumper

Depending on the model year and version of the attachment may vary slightly.

-open the tailgate and remove the trim.

-under the pickguard screws and bumper pads under the rear lights.

-remove the lining under the tail lamps traffic to the middle of the trunk.

-in the boot remove the side trim and twisted wings two screws on each side.

-Unscrew the screws in the wheel arches (not remove the wheels, loosen the ratchet with a nozzle).

-with the assistant pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

the attachment of the rear bumper SKODA OCTAVIA 1

the scheme of fastening of the rear bumper SKODA OCTAVIA 1