Front bumper
Depending on the model year and version of the attachment may vary slightly.
-open the hood and Unscrew the three screws that secure the grille (spun down) and release it from the clips.
-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches Unscrew the screws that attach the fender liner to the bumper.
-move the wing flaps to the side and Unscrew one screw on each side that attach the bumper to the wings (spun up).
-at the bottom, take out the caps (inserted from the bottom up).
-pull the edges to the side, releasing the latches, and pulls the bumper forward from the rails.
-remove the connectors from the fog lights (if any).
-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.
-remove connector from the PDC (if any).
Rear bumper
-in the trunk, side panels, removable access doors opposite of the rear lights.
-under the hatches, Unscrew the nuts and remove the tail lights.
-Unscrew the four screws in the opening of the trunk.
-wheel arches Unscrew the screws that attach the bumper to the wings (spun up).
-at the bottom, take out the caps (inserted from the bottom up).
-tear the corners with the latches under the wings.
-release the clips under the rear lights.
-with the assistant pulls the bumper from the guides themselves.
-remove the electrical connector license plate light.
-remove connector from the PDC (if any).