-
-
-
Skoda Superb III (B8) (2015+)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood, unscrew the two screws and take out the two pistons that secure the upper part of the bumper (the grille trim).
-around the perimeter of the lower part, unscrew the ten screws (spun up) that secure the engine protection and fender liner.
-turn the wheels to the side.
-in the wheel wells, unscrew three screws on each side that secure the fender liner (front).
-move the fender liner to the side and unscrew two screws on each side (spun up) that secure the corners of the bumper to the wings.
-with an assistant, release the clips in the wings and pull the bumper forward (look behind the wires and hoses).
-disconnect electrical connectors.
-(if any) disconnect the headlight washer hoses.
Rear bumper
-open the trunk lid.
-in the opening of the trunk, remove the lining of the rear lights (hold on latches, you need to pry).
-under the overlays, unscrew two screws on each side and remove the rear lights (held by clips in the wings).
-around the perimeter of the lower part of the bumper, Unscrew ten screws (spun up).
-in the wheel wells, unscrew three screws on each side that secure the fender liner (rear).
-move the fender liner to the side and unscrew one screw on each side (spun down) that attach the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-we release the latches under the rear lights and in the opening of the trunk.
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español