-
-
-
Front bumper
Depending on the model year and version of the attachment may vary slightly.
-open the bonnet and Unscrew the nuts securing the headlight.
-release the latches (in corners of the headlight, near the radiator) and pull headlight forwards.
-Unscrew the screws under the headlights (spun down).
-Unscrew the screws in front of the radiator (twisted upside down).
-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches Unscrew the screws that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.
-Unscrew the screws and take out the caps on the perimeter at the bottom of the bumper (spun up).
-remove decorative plugs near the fog lights (mounted on the latches).
-under the plugs, Unscrew one screw on each side.
-remove the bumper from the guides movement in front.
-remove connector from the PDC (if any).
-if you have fog lights, remove the connector.
-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.
Rear bumper
Depending on the model year and version of the attachment may vary slightly.
-in the boot remove the side trim and Unscrew the nuts that attach the rear lights.
-remove tail lights.
-also for coverings Unscrew the screws that attach the bumper to the wings.
-under the tail lights remove the cover cap.
-under the covers Unscrew two screws on each side.
-Unscrew the screws in the wheel arches (not to remove the wheel, remove ratchet with a nozzle).
-Unscrew the screws around the perimeter in the bottom (spun up).
-with the assistant pulls the bumper from the guides themselves.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español