How to remove front and rear bumper SKODA ROOMSTER

Front bumper

Depending on the model year and version of the attachment may vary slightly.

-open the hood, Unscrew two screws and remove two pistons (spun down).

-near the fog lights, remove the grille (mounted on the latches).

-under the bars Unscrew one screw on each side.

-Unscrew the screws and take out the caps on the perimeter at the bottom of the bumper (spun up).

-Unscrew the wheel to the left or right side, depending on which side will parse the first.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and twisted the wings on the two screws on each side (twisted from the top to the bottom) that attach the angles to the wings.

-pulls the bumper itself.

-remove connector from the PDC (if any).

-if you have fog lights, remove the connector.

-if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.

Rear bumper

Depending on the model year and version of the attachment may vary slightly.

-open the boot lid and twisted in the opening one screw on each side under the rear lights.

-take out the caps in the lower part (inserted from the bottom up).

-Unscrew the screws in the wheel arches (not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and take out one piston on each side in the corners (inserted from the bottom up).

-with the assistant pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).