How to remove front and rear bumper Mercedes C-Class W203

Front bumper

-in the lower part of the bumper, Unscrew the screws that attach the engine protection to the bumper (if any).

-Unscrew the wheel left or right depending on which side will Unscrew first.

-wheel arches Unscrew the screws that attach the fender liner to the bumper.

-move the wing flaps to the side and Unscrew one bolt on each side (spun up), then remove the retaining brackets that connect the bumper and fenders.

-open the hood and Unscrew one screw on each side between the radiator and the headlamps (spun down).

-around the fog lamp take out the plugs  and Unscrew one nut on each side.

-with the assistant pulls the bumper itself.

-remove the connectors from the fog lights.

-if there is paramilitary disconnect the hoses from the injectors and close them with stoppers that from the reservoir was leaking fluid

-if you have sensors, remove the connector.

Rear bumper

-in the wheel wells, Unscrew the screws and pull out the rivets that attach the fender liner to the bumper (so as not to remove the wheels, use a ratchet with a nozzle).

-the left and right sides move the wing flaps to the side and Unscrew the bolts that attach the bumper to the wing (spun up).

-the edges at the bottom of the bumper, Unscrew two bolts on each side.

-in the trunk lift the lid of the spare wheel.

-remove side trim and pockets (need to access the tail lights).

-under sheathing, below the rear lights, Unscrew  four nuts and one bolt on each side holding the bumper together with the amplifier to the body.

-pulls the bumper on yourself (do it better with an assistant, so as not to scratch the paint).

-remove connector from the PDC (if any).

-the bumper is cleared.

How to remove front and rear bumper Mercedes C-Class W202

How to remove front and rear bumper Mercedes C-Class W204

How to remove front and rear bumper Mercedes C-Class W205