-
-
-
Front bumper
The bumper is removed very simply.
-Unscrew the wheel left or right depending on which side will Unscrew first.
-wheel arches get the rivets that attach the fender liner to the bumper.
-move the wing flaps to the side and Unscrew two screws on each side (spun upwards) holding the bumper to the wings.
-under the hood remove the air intake (held on latches).
-under the hood Unscrew the three bolts that secure the grille to the top of the bar.
-remove the grille (lower grille attach to the side of the radiator, pulling off with latches and pulls her up).
-pulls the bumper itself.
-remove the connectors from the fog lights.
-if there is paramilitary disconnect the hoses from the injectors and close them with stoppers that from the reservoir was leaking fluid
-if you have sensors, remove the common connector.
Rear bumper
-wheel arches take out the rivets that attach the fender liner to the bumper.
-move the wing flaps to the side and Unscrew the screws holding the corners of the bumper to the wings (spun upwards).
-perimeter of the bottom of the bumper, Unscrew the screws under the asterisk.
-in the trunk remove the rear panel (holding latches).
-under panel, Unscrew the two nuts.
-at the corners of the bumper pull to the side and pulls back (better to do it together not to scratch the paint).
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español