How to remove front and rear bumper Mercedes CLS C219

Depending on the year and configuration of the attachment locations can vary. If the bumper has never been withdrawn, unable to stand rivet which must be drilled out.

Front bumper

-open the hood.

-under the hood, Unscrew the two screws near the headlights, and three over the grille that secure the upper part.

-remove the bottom grille (rests on the latch, pull on yourself) and Unscrew her two screws (spun up).

-take out the caps on the perimeter of the lower part (inserted from the bottom up).

-wrenched the wheel to the side.

-wheel arches take out the caps and removed the wheel arches (the front part).

-for wheel arch liners Unscrew one on each side (spun upwards) holding the corners of the bumper to the wings.

-release the clamps that secure the corners to the fenders (pull toward the engine and yourself).

-with the assistant pulls the bumper forward from the rails in the wings (look for wires).

-release the connectors for fog lamps (easier to remove chocks from light bulbs), turn signals, Parking sensors and temperature sensor (if any).

-if you have headlight washers, disconnected the hoses.

Rear bumper

-open the trunk lid.

-in the trunk remove the plastic cover of the rear panel.

-the plating of the rear panel Unscrew the six nuts.

-we release the side Luggage compartment trim (need to access the inner part of the wings).

-in the inner part of the fenders Unscrew two of wine (swirling from top to bottom) on each side.

-Unscrew the screws around the perimeter of the bottom (spun up).

-wheel arches take out the caps and removed the wheel arches (rear).

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of the equipment (if any).

How to remove front and rear bumper Mercedes CLS C218