Depending on the year and model of attachment can vary.

Front bumper

-open the hood.

under the hood, Unscrew the five screws (spun down) that secure the upper part.

-Unscrew the seven screws around the perimeter of the bottom (spun up) that secure the protection and wheel arches.

-wrenched the wheel to the side.

-wheel arches take out two pistons on each side and removed the wheel arches (the front part).

-attach the fender liner to the side and Unscrew two screws on each side holding the bumper corners to the wings.

-release the fasteners in the wings (pull the corners of the bumper visas and yourself).

-with the assistant pulls the bumper forward (look for wires).

-release the connectors on the Parking sensors, fog lights, temperature sensor (if any).

the attachment of the front bumper of the Mercedes B-Class W246

Diagram of rear bumper Mercedes Mercedes B-Class W246

 

 

Rear bumper

-open the trunk lid.

-in the trunk remove the plastic cover of the rear panel.

-the lining in the back panel, Unscrew the two nuts.

-Unscrew the screws (spun up) that secure the lower part.

-in the wheel wells, Unscrew the screws and peel the fender liner (rear part).

-the fender liner, Unscrew the screws holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves).

-release the clips under the rear lights.

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of electrical equipment.

the attachment of the rear bumper of the Mercedes B-Class W246

The scheme of fastening the rear bumper of the Mercedes B-Class W246